SearchAsk us anythingarrow rightCan I install a water hammer arrestor horizontally?Not one. Sioux head sensors can be installed vertically, horizontally or at any angle in the center.Let's Get It Fixed!Our virtual experts can diagnose your issue (for free!) and resolve simple problems.Chat with a live expertChat nowCall 1 (855) 466-3948Call nowRATESHARECopy linkTwitterFacebookmagnifying glassLink copied to clipboard.SUBMIT AN ANSWERShop Recommended ProductsShop HomeX Recommended ProductsRELATED QUESTIONSDo you need water hammer arrestor for PEX?Water hammers can be installed in the PEX pipe. If you hear a loud noise inside your pipe, it is probably the fault of the water hammer. The phenomenon is potentially destructive to your pipes over time and should be administered using a device known as a water hammer.Can you install a water hammer arrestor upside down?For dishwashers, viticar on the right side of the male, face down the side. For dishwashers and other appliances, use compression accessories. Controllers must always be installed as close as possible to the noise-producer device.Where should water hammer arrestor be installed?Most hammers are installed in the wash machine valves, but instructions may recommend direct connection to the back of the wash machine in order to protect the wash machine tubes.Can I install backflow preventer?In order to ensure adequate protection of water supply, flow valves can be installed outside and above the level. In order to protect the devices themselves, protective shells are used.Can a PRV be installed horizontally?The horizontal installation is recommended. However, the valve can be installed in a vertical position. When using the reduction valve, a closed system is made, so that the pressure protection must be provided on the back side of the reduction valve to protect the equipment.