Cover the mesh tape with a dry wall joint, using an elastic knife. Press firmly the compound together in the small mesh holes of the tape, completely covering the mesh tape. Spread the mud over the edges of the tape around the two inches on the surfaces of the wall and ceiling.

Press the tile on the thin floor and slide it perpendicularly to the combed lines. If your old ceramic tile is used or dated, you can put new tiles right into the old one, and avoid the immense work of tearing the old tile.

Fill the gap up to 14 inches wide with caulk. If you have tiles on the wall adjacent to the bath tub, select a caulk that corresponds to the color of the cave. If your width is less than 18 inches, use caulk normally fill the gap larger than 18 inches with a dirty caulk.

Remove the dishwasher and place the 1-inch stand at the bottom of the counter, with an end of the L-support against the adjacent cabinet and the face that extends over the hole. Install the stand 12 inches behind the front of the cabinet.

Design the distribution lines of the level tiles and the condiments on the wall to guide your installation. Measure a line of screens to determine the position of the shower tiles in the back wall. Replace about 34 inches of height of the tile and use this measure to locate the height of the level tiles in the bathtub or shower.